An underground dog fence can be an excellent addition to your home. Not only can protect your dog may encounter bizarre zoning in your area or no negative impact on the appearance of your home. But despite all these advantages, has a disadvantage, the, there is a break in the line. A pause can be used for a variety of different reasons, such as the wire manipulations approved a critter at the border, or simply experience the lineotherwise perfect functioning over time elements or obsolescence.
Fortunately it is not so hard to find a break in a line and replace it either. Even better is that the additional wiring is not expensive, the process is completely manageable for anyone with a little 'do-it-yourself knowledge.
Here we provide a list of steps you use to find the break. However, you should also know that it is enough to buy a wireless device on-line detector. This device isHelp, where the break is almost immediately and help you save time in the process. If a device detector line is not in your budget, you can use the following steps:
1 Disconnect the transmitter to the fence.
2 Take the two ends of the wire and the terminal.
3 Take a test wire from a piece of wire that about half the length of the full length of the wire.
4 Use one side of the test wire to connect the wire to the terminal.
5Find half of the regular wire and cut it into two pieces.
6 From here you take the test lead to one of the pieces of wire perimeter. You must add the two parts spliced together.
7 Turn off the transmitter enclosure and make sure the loop is executed the right light. If so, you know, the break is in another part of the barbed wire fence. If not, the pause in the part that is connected.
8 Which part is the pause to change them,the thread has new piece of wire wit.
9 Then add the new wire back to the original fragment and not turn the station fence.
10 If it works right now, you can move the dog collar should check and be done at this point.
0 comments:
Post a Comment